Kvalitet, Service, Utbud

VFC Colt XM177E2 GBB

Artnr: 32471
7 599 kr
I lager. Leveranstid 1-3 dagar.
På fjärrlager. Leveranstid 4-6 veckor.
Endast få kvar i lagret (0 st)
På fjärrlager. Leveranstid 4-6 veckor.
Bevaka produkt

Ange din e-postadress nedan så meddelar vi dig när produkten finns i lager! Din e-postadress sparas i upp till 180 dagar.

Produktbeskrivning
Egenskaper

En klassisk XM177E2 från VFC med licens från Colt.

VFC Colt XM177E2 är en helhjärtad replika av den legedariska karbinen, helt licensierad från Colt. Detta betyder att du finner de korrekta gravyrerna på detta vapen som den riktiga motsvarigheten har. Lika så det fasta bärgreppet, den 2-stegs justerbara kolven och de fasta riktmedlet. Detta är VFC´s senaste Gen 3 utgåva vilket betyder att den har fått en rad uppdateringar så som förbättrat slagstift, nya magasin. En extremt fin vapenmodell med absolut högsta kvalite.

Geväret tar VFC´s vanliga M4 gas magasin 

Tillverkad helt i metall och har en extremt fin känsla.

...............................

The Dagger of Men with Green Faces

The CAR-15(Colt Automatic Rifle-15 Military Weapons System)was developed by Colt in the 1960s based on the design of the AR-15, its XM177 series was active during the Vietnam War. Before the XM177 series was used in the U.S. Army, it was called the CAR-15 Commando. It was a "submachine gun" launched in response to the request of the US military in 1966. The CAR-15 Commando is similar to the Colt M607 submachine gun and the shortened version of the M16 rifle with notable differences: It is designed with an aluminum alloy two position retractable buttstock, the old handguard was replaced with a shortened round handguard, and it is equipped with a 4.25-inch muzzle device. However, the size of the upper and lower handguards are exactly the same.

The U.S. Army launched the CAR-15 Commando in 1966 and named it the "Submachine Gun, 5.56 mm, XM177E1". After feedback and suggestions from users, Colt improved the XM177E1. In 1967 the U.S. Army purchased it for the Its Military Assistance Command, Vietnam-Studies and Observations Group (MACV-SOG) in the new CAR-15 assault type variant and named it XM177E2.

Although the new flash hider could effectively reduce the muzzle flash, there were other serious problems. Due to the short muzzle and barrel length of the XM177E2, the gunpowder that has not been fully burned when firing will quickly block the flash hider. The flash hider, if it is not cleaned, will significantly lose its sound reduction benefits. In addition, the flash hider would also cause problems with the shooting accuracy of ordinary bullets, which was even more serious when using tracer bullets.

 
After the improvement failed due to these issues, the U.S. Army canceled many XM177E2 orders in 1969. Because the gun could not be officially deployed in the U.S. military, the prefix "X" representing "eXperimental" in front of the XM177 series has never been removed.
The XM177E2 was not favored by regular troops in the Vietnam War, and some veterans of MACV-SOG have different evaluations in their memories. Many think in retrospect that the XM177 series is the favorite of "SOG".

 
And although the ballistic condition of the 11.5-inch barrel is relatively low, both its effect used on close combat in the jungle, and the unstable trajectory that makes the bullet enter the enemy's body off balance and cause considerable damage made it an effective tool for those special operations.
Another special forces unit that also liked to use the XM177 series in the jungles of Vietnam was the US Navy SEALs. After the Vietnam War, the SEALs and Army Special Forces continued to use the XM177 series until the production of Curt 635 as they were beginning to phase out this “legend” of Vietnam War.

No Compromise!

GET VFC!

The styling is taken from the Colt XM177E2 in the Vietnam War. It includes the unique XM177 flash hider, the 11.5-inch outer barrel, M16A1 style front sight, special CAR-15 skinny round carbine handguard, A1 type lower receiver, carrying handle upper receiver, early-type dummy forward assist knob, early-type aluminum alloy 2 position retractable buttstock, etc... plus the lower receiver with a fully authorized Colt marking and US DOD Stamp; all the appearance details of the Colt XM177E2 are integrated in one place.

 
The GBBR is not only upgraded with the newly designed "Non-cut lever" Steel Hammer Set, but also the structure of the lower receiver has been improved: The fitting depth has been increased, and the structure of the firing pin base parts are greatly simplified, making the valve striking action more stable. Due to this, the durability of the parts are effectively improved, and the maintenance of this replica is easier for the end user. (Note: This new lower receiver can be directly assembled with previous VFC M4 GBBR upper receiver.)
The VFC XM177E2 GBBR this time has not only has the authorization from Colt, but also gained the full upgraded internals of the VFC AR GBB system: including the new improved Lower Receiver Internal structure, the improvement of the firing pin design and newly designed "Non-cut lever" steel hammer set, a new setting buffer spring, and newly designed gas magazine. All of these improvements lend to an overall performance and durability increase in the XM177E2!
  • Improved V3 Lower Receiver Internal Structure

     

  • Improved Internal Structure Improve Performance In One Piece

VFC Colt XM177E2 GBBR is built under license by Cybergun, with fully authorized markings, lending to a faithful reproduction of the XM177E2 in Vietnam War… including all details and engravings.
  • Details Of The Vietnam War Version XM177E2:

     

  • Cybergun Full License Authorized Production

     

 

Läs mer
Stäng
Vikt2590g
Längd760mm
Utgångshastighet (0,20g)115m/s
Hop UpJa, Justerbar
Gänga (ytterpipa)-14mm
Magasinkapacitet20
MagasintypM4
MaterialMetall
Rekommenderad kulvikt0.25g
BlowbackJa
DrivningGas
Rekommenderade tillbehör till denna produkt
Drift & produktion: Wikinggruppen